How to get NI controller editor to recognize my Komplete Control MK2

Mr.Bill · 4:56PM

Is there a Firmware update that is needed?

LostInFoundation · 5:12PM

It should not be the firmware (Controller Editor should see it anyway). In any case, last firmware version is 1.4.0. If that is not what you have, you can find the updater here:

https://www.native-instruments.com/en/support/downloads/drivers-other-files/

One culprit for the keyboard not being recognized could be NIHardwareAgent not running in background. Check it in Task Manager. (Point 4 of this support article:)

https://support.native-instruments.com/hc/en-us/articles/4410096148113-My-Native-Instruments-Hardware-Device-is-Not-Recognized

While you’re there, check also the other points 😉

PoorFellow · 5:18PM

https://community.native-instruments.com/discussion/44625/how-to-get-ni-controller-editor-to-recognize-my-komplete-control-mk2

How to get NI controller editor to recognize my Komplete Control MK2

CC @LostInFoundation :

Quote :

Different hardware controllers will allow for different abilities in the configuration of their outgoing MIDI Control Changes. If your controller does not appear in Controller Editor, it is due to the reasons listed below:
Hardware Controllers which are configured from their Application
Komplete Kontrol S-Series MK2
Komplete Kontrol A Series
Komplete Kontrol M32

Ref. : My Native Instruments Controller does not Appear in Controller Editor

Also :

last firmware version is 1.4.0

For Komplete Kontrol S-Series MK2 then latest firmware is Firmware version 0.5.9 or firmware version 0.6.0 depending on when you bought the keyboard. Keyboards with firmware less than 0.6 can not be upgraded beyond firmware 0.5.9

LostInFoundation · 5:30PM

True…forget what I said… it’s not the case for MK2 if it’s only Controller Editor that doesn’t recognize it

How to get NI controller editor to recognize my Komplete Control MK2

Answers

Categories