Expert Advice Please....No Sound S61 Mk3 Logic Pro X SSL 12

raffles1968
raffles1968 Member Posts: 2 Newcomer
in Komplete Kontrol

Hope someone could help me with the above setup, I have ensured output as SSL12, Control Surface selecting S61 Mk 3. I could not get any sound of the the keyboard which lights up when I pressed the notes but nothing else happens, and it cannot even control a track within Logic Pro.

I must be missing something, hope to have some expert advice please!

Answers

  • babble.catalog
    babble.catalog Member Posts: 18 Newcomer

    To rule out whether its your output/interface of the S61 — are you SEEING signal in Logic Pro? If you are seeing the signal, but not hearing it, that is likely a problem with your output settings or interface.

    If you aren't seeing the S61 create sound when linked to a MIDI/VST Instrument in Logic, then are you sure you are using the S61 as your MIDI input on that VST channel?

    If you don't see the S61 as an option, make sure you've downloaded all necessary drivers and you can see S61 in Audio MIDI Setup.

    If none of that works, make sure you aren't using MIDI 2.0. Atleast for me, that caused a lot of problems for me. I would use MIDI 1.0 for now until 2.0 is more widely adopted.

  • raffles1968
    raffles1968 Member Posts: 2 Newcomer

    Thanks so much for your advice! Please see my inputs below:

    To rule out whether its your output/interface of the S61 — are you SEEING signal in Logic Pro? If you are seeing the signal, but not hearing it, that is likely a problem with your output settings or interface.

    No signal when S61 is plugged directly to Mac Studio (2024) thunderbolt port at the rear.

    If you aren't seeing the S61 create sound when linked to a MIDI/VST Instrument in Logic, then are you sure you are using the S61 as your MIDI input on that VST channel?

    Only when i used a MIDI cable connecting my S61 (midi out) to my SSL12 (midi in), I got sounds when trying out Arturia V Collection.

    If you don't see the S61 as an option, make sure you've downloaded all necessary drivers and you can see S61 in Audio MIDI Setup.

    All drivers for SSL12, S61 were updated and current.

    I will try to launch Logic Pro X to see if it works, suspect with the midi cable connected, it may work.

    All audio settings in Logic Pro X has been set to SSL12 as audio out.

    Rightfully, I do not need MIDI cable as both SSL12 and S61 are plugged directly into Mac Studio via thunderbolt port behind. They should talk to each other, unless there are some settings that are incorrectly configured which I hope someone with similar setup can help!

    Thanks in advance!

    Regards,

    Michael

Back To Top

Categories