Kontakt 7 Only Shows 2 Stereo Outs

Hi there,
I've been struggling with this for weeks now, and NI support takes so long to reply. I recently upgraded to Kontakt 7, but when I go to route multiple tracks out of Kontakt 7, I only have 1 stereo out available.
I have tried deleting the default folder as instructed to reset to factory settings but to no avail. This makes it so I can't route individual instruments out of a single instance of Kontakt, which kind of makes my whole workflow not work. Please see attached screenshot.
Any suggestions? Thank you!
Best Answer
-
You didn't get back to us. We’re closing this thread now. If you still need assistance on that topic, please get in touch here: http://bit.ly/NIsupport_kontakt
0
Answers
-
Hey @spensersembrat It would have helped to give more context, both here and in your support request. I was able to get the full picture only because I went through your request and you finally mentioned in what DAW this is happening, FL Studio. So have you followed these steps? How to Route KONTAKT to Multiple Outputs in FL Studio
0 -
You didn't get back to us. We’re closing this thread now. If you still need assistance on that topic, please get in touch here: http://bit.ly/NIsupport_kontakt
0
Categories
- 9K All Categories
- 17 Welcome
- 393 Hangout
- 57 NI News
- 178 Tech Talks
- 929 Native Access
- 4.2K Komplete
- 521 Komplete General
- 943 Komplete Kontrol
- 1.6K Kontakt
- 417 Reaktor
- 133 Battery 4
- 228 Guitar Rig & FX
- 171 Massive X & Synths
- 176 Other Software & Hardware
- 2K Maschine
- 19 Sampling Room
- 2.2K Traktor
- 2K Traktor Software & Hardware