Welcome to the new and improved Native Instruments online community. Join our active forum of 40,000+ members for discussions and much more.
Ozone 10 / Komplete 14 - Native Access Shows "not installed" but is open in DAW

hendosyndrome
Member Posts: 3 Sine
I upgraded yesterday and have completed the installation of everything, except that is of Ozone 10 which is leaving me confused.
I've read the article about "Full Trial" in the Izotope product portal and have made sure that I downloaded and installed from native access but that portal isn't showing it as installed.
However, when I check Logic the AU is showing and will run.
Is this normal? Have I done something wrong?
Any help appreciated.
Tagged:
0
Comments
-
Same issue I'm experiencing.
0 -
Same here. I was not told that it would be a plugin-only version of Ozone 10 that would be available, and I am still waiting for the full version to install on my system though right now it seems somewhat impossible.
0
Back To Top
Categories
- 10.7K All Categories
- 20 Welcome
- 444 Hangout
- 58 NI News
- 207 Tech Talks
- 1.1K Native Access
- 4.9K Komplete
- 619 Komplete General
- 1.1K Komplete Kontrol
- 1.8K Kontakt
- 486 Reaktor
- 154 Battery 4
- 268 Guitar Rig & FX
- 202 Massive X & Synths
- 212 Other Software & Hardware
- 2.3K Maschine
- 14 Sampling Room
- 2.6K Traktor
- 2.4K Traktor Software & Hardware
- Check out everything you can do
- Create an account
- See member benefits
- Answer questions
- Ask the community
- See product news
- Connect with creators