Can ADSR Knobs Automatically Change Per Group?

I have a set of basic ASDR knobs, and some key switches and ui buttons that change which group is being played. Everything works fine however, the ADSR values will just display for group 1. If I hit a keyswitch or button to only allow group two, the ADSR values don't change. Is there a way for them to automatically change based on which group is currently being played? My apologies I am super super new to coding.
Best Answer
-
Yes, you can do that, you would set the value of each knob by using get_engine_par() command.
0
Answers
-
Yes, you can do that, you would set the value of each knob by using get_engine_par() command.
0 -
OMG thank you so much for taking the time to answer! You have helped so many. Just by reading your responses to people in other older messages helped me learn.
I haven't got it working correctly yet, but now that I know that's the code to use, I am sure I will figure it out eventually.
0 -
@EvilDragon I got it! Thank you! I ended up doing
on ui_control ($ks1) $attack := get_engine_par($ENGINE_PAR_ATTACK,0,1,0) set_knob_label($attack,_get_engine_par_disp($ENGINE_PAR_ATTACK,0,1,0))
Then changing the group number for each new ui_control switch I had set up already.
0
Categories
- 9K All Categories
- 17 Welcome
- 394 Hangout
- 57 NI News
- 179 Tech Talks
- 930 Native Access
- 4.2K Komplete
- 521 Komplete General
- 950 Komplete Kontrol
- 1.6K Kontakt
- 418 Reaktor
- 134 Battery 4
- 228 Guitar Rig & FX
- 173 Massive X & Synths
- 176 Other Software & Hardware
- 2K Maschine
- 19 Sampling Room
- 2.2K Traktor
- 2K Traktor Software & Hardware