If you have a Moog EP-3, could you share how you got it to work with KK Mk3?

standzig
standzig Member Posts: 2 Newcomer

I've tried every combination of settings, multiple cables, switching to assign 1, adjusting the dial on the right side of the pedal, flipping the switch on the bottom of the pedal, multiple instruments and patches in KK and Kontakt, nothing seems to work. I hooked it up to a Boss GX-100 and it works, though not smoothly. I used the touchstrip on a patch and it was registering on the MK3's screen but when I switched to the expression pedal, nothing. I've searched this and multiple other forums, trying every suggestion I could find and I'm honestly at a loss. I thought this pedal was supposed to be plug and play, essentially, but I cannot seem to figure it out. Any help or suggestions would be much appreciated even if they seem obvious!

Best Answer

  • standzig
    standzig Member Posts: 2 Newcomer
    Answer ✓

    I tried assign 2 this time. I used Continuous/On/Ring, calibrated, and it worked! So I switched to the Expression input with the same settings, calibrated, and it works there too now. So if anyone has the same issue I had…

    Continuous/On/Ring, the switch underneath the pedal is set to Standard, and the dial on the right side is all the way up.

    Not sure why it started working now but I'm glad it did!

Answers

  • standzig
    standzig Member Posts: 2 Newcomer
    Answer ✓

    I tried assign 2 this time. I used Continuous/On/Ring, calibrated, and it worked! So I switched to the Expression input with the same settings, calibrated, and it works there too now. So if anyone has the same issue I had…

    Continuous/On/Ring, the switch underneath the pedal is set to Standard, and the dial on the right side is all the way up.

    Not sure why it started working now but I'm glad it did!

  • RikkiB
    RikkiB Member Posts: 5 Newcomer

    I also have a Moog EP3 pedal.
    I haven't been able to get it to work with S61 Mk 3.

    This is really basic, and deeply frustrating.

    The pedal works fine with an old Roland controller.

    I've tried it in Expression, Assign 1 AND Assign 2. No joy.

    I've factory reset the keyboard and tried all again.

    If I set it to SWITCH rather than CONTINUOUS it shows a signal, switching between 1 and 127 values, but the moment it's on CONTINUOUS it goes silent.
    This would seem to be a very basic thing for a MIDI controller to handle. I'm beginning to rue the day I bought this keyboard - so many issues, and this pedal business is frankly ridiculous.

    I've searched the internet for answers and all I see is people with problems, some of whom (like above) manage to get something working through an illogical quirk, but it all seems to be guesswork and luck of the draw.

    Are we going to get an urgent firmware update to resolve this and other issues?

Back To Top