Maschine studio hangs on startup screen
so when i google i find an old post about this it seems but when i click through it isnt on here.
basically as the title, it lights up all the colors phase across then just hangs on the maschine - groove production screens... Any advice, is there a hard reset of the hardware ?
Best Answer
-
It's not a midi controller in that sense. You need a few services that are usually installed with the maschine software, controller editor, driver, etc.
1
Answers
-
I could be wrong, but I don't think there is anything wrong with the Maschine Studio hardware. I believe this is a software issue or a bad USB cable.
Is the Maschine software properly installed? If so, try using another USB cable.
1 -
I have tried a few different cables so that doesnt seem to be the issue, the controller should boot in to midi mode though regardless of the maschine software being installed right ?
0 -
It's not a midi controller in that sense. You need a few services that are usually installed with the maschine software, controller editor, driver, etc.
1 -
@darkwaves is absolutely right! In case it does not work, check this article:My MASCHINE Controller Does Not Start
0
Categories
- All Categories
- 18 Welcome
- 949 Hangout
- 56 NI News
- 471 Tech Talks
- 2.5K Native Access
- 11.1K Komplete
- 1.3K Komplete General
- 3K Komplete Kontrol
- 3.9K Kontakt
- 842 Reaktor
- 298 Battery 4
- 611 Guitar Rig & FX
- 325 Massive X & Synths
- 761 Other Software & Hardware
- 4.1K Maschine
- 4.8K Traktor
- 4.8K Traktor Software & Hardware
- Check out everything you can do
- Create an account
- See member benefits
- Answer questions
- Ask the community
- See product news
- Connect with creators