M+ scene change by the grid
WarriorLite
Member Posts: 67 Member
in Maschine
Can this be set to happen in sync?
One way is to get this done via arrangement, but manually?
0
Best Answer
-
From the Maschine Plus Manual, page 193:
17.1.4. Performing with Scenes and Sections
MASCHINE+ provides you with settings to fine-tune the timing of the jump between the Scenes and Sections:
- The Perform Grid lets you quantize the Scene transitions: You can choose the point at which the playback will leave the current Scene (Ideas view) or Section (Song view). For example, you might not want a newly selected loop to fire off immediately, you might want it to wait until the next bar line. The available quantization values are: one bar, one-half note, one-quarter note, one-eighth note, one-sixteenth note, the whole Scene/Section, and Off. If you choose Off, the Scene/Section change will be performed immediately after you select the next loop.
0
Answers
-
From the Maschine Plus Manual, page 193:
17.1.4. Performing with Scenes and Sections
MASCHINE+ provides you with settings to fine-tune the timing of the jump between the Scenes and Sections:
- The Perform Grid lets you quantize the Scene transitions: You can choose the point at which the playback will leave the current Scene (Ideas view) or Section (Song view). For example, you might not want a newly selected loop to fire off immediately, you might want it to wait until the next bar line. The available quantization values are: one bar, one-half note, one-quarter note, one-eighth note, one-sixteenth note, the whole Scene/Section, and Off. If you choose Off, the Scene/Section change will be performed immediately after you select the next loop.
0 -
Thank you.
0
Back To Top
Categories
- All Categories
- 22 Welcome
- 2.2K Hangout
- 86 NI News
- 1.5K Tech Talks
- 2.6K Native Access
- 14.2K Komplete
- 1.4K Komplete General
- 3.1K Komplete Kontrol
- 4.1K Kontakt
- 3.6K Reaktor
- 342 Battery 4
- 639 Guitar Rig & FX
- 329 Massive X & Synths
- 794 Other Software & Hardware
- 4.2K Maschine
- 5.3K Traktor
- 5K Traktor Software & Hardware
- Check out everything you can do
- Create an account
- See member benefits
- Answer questions
- Ask the community
- See product news
- Connect with creators