M+ scene change by the grid

WarriorLite
WarriorLite Member Posts: 67 Member

Can this be set to happen in sync?

One way is to get this done via arrangement, but manually?

Best Answer

  • ozon
    ozon Member Posts: 1,302 Expert
    Answer ✓

    From the Maschine Plus Manual, page 193:

    17.1.4. Performing with Scenes and Sections

    MASCHINE+ provides you with settings to fine-tune the timing of the jump between the Scenes and Sections:

    • The Perform Grid lets you quantize the Scene transitions: You can choose the point at which the playback will leave the current Scene (Ideas view) or Section (Song view). For example, you might not want a newly selected loop to fire off immediately, you might want it to wait until the next bar line. The available quantization values are: one bar, one-half note, one-quarter note, one-eighth note, one-sixteenth note, the whole Scene/Section, and Off. If you choose Off, the Scene/Section change will be performed immediately after you select the next loop.

Answers

  • ozon
    ozon Member Posts: 1,302 Expert
    Answer ✓

    From the Maschine Plus Manual, page 193:

    17.1.4. Performing with Scenes and Sections

    MASCHINE+ provides you with settings to fine-tune the timing of the jump between the Scenes and Sections:

    • The Perform Grid lets you quantize the Scene transitions: You can choose the point at which the playback will leave the current Scene (Ideas view) or Section (Song view). For example, you might not want a newly selected loop to fire off immediately, you might want it to wait until the next bar line. The available quantization values are: one bar, one-half note, one-quarter note, one-eighth note, one-sixteenth note, the whole Scene/Section, and Off. If you choose Off, the Scene/Section change will be performed immediately after you select the next loop.
  • WarriorLite
    WarriorLite Member Posts: 67 Member

    Thank you.

Back To Top