How to do a velocity amount knob?

interceptor
interceptor Member Posts: 8 Member
edited November 2022 in Building With Reaktor

Hi, Im building my first synth, and I found a couple of tutorials online that seem to cover the basics.

But Im trying to make a knob that can set the amount of velocity response. Like if the knob is down at 0 = zero velocity sensitivity (fixed velocity). And at full 1 = full velocity sensitivity. How would I go about setting up something like that?

The end goal is then to connect this to filter cutoff and other stuff to have velocity control over, But that Its the velocity amount thing that I cant figure out.

So If anybody could help, maybe via a screenshot or something it would be greatly appriciated :)

Comments

  • Paule
    Paule Member Posts: 1,328 Expert
    Answer ✓

    here is one from an existing ensemble

  • interceptor
    interceptor Member Posts: 8 Member

    Awesome! So nice that you even added the file.

    Gonna check it out. Thanks so much :) 🙏

  • interceptor
    interceptor Member Posts: 8 Member

    Tested it now. Works perfectly. Thanks again :)

  • Paule
    Paule Member Posts: 1,328 Expert

    Tested it now. Works perfectly.

    That's fine. - An attached file better than in image in my humble opinion.

  • Paule
    Paule Member Posts: 1,328 Expert

    In Steam Pipe 2 in the factory library is another velo control. Test it please.

Back To Top