S2 MK3 move and loop encoders doesn't work on one side
subaru418
Member Posts: 1 Member
Hi
I just bought a used TRAKTOR S2 MK3 and when I plugged it into TRAKTOR 3 PRO at home I noticed that I could not enter or exit a loop using the loop encounter and it's happening only on one of the sides.
I also tried to map those encounters but the software seems to not be getting any signal out of them when I push them. Turning works perfectly.
Tagged:
0
Answers
-
Then it is most likely defective. You could try to start the S2 in midi mode and use a program like midiox as midi monitor, then check if and what signal every knob and button sends. You can go into midi mode like this: https://support.native-instruments.com/hc/en-us/articles/360006377918-How-to-Switch-Your-TRAKTOR-KONTROL-S2-MK3-to-MIDI-Mode
0
Back To Top
Categories
- All Categories
- 22 Welcome
- 2.2K Hangout
- 86 NI News
- 1.5K Tech Talks
- 2.6K Native Access
- 14.2K Komplete
- 1.4K Komplete General
- 3.1K Komplete Kontrol
- 4.1K Kontakt
- 3.6K Reaktor
- 342 Battery 4
- 639 Guitar Rig & FX
- 329 Massive X & Synths
- 794 Other Software & Hardware
- 4.2K Maschine
- 5.3K Traktor
- 5K Traktor Software & Hardware
- Check out everything you can do
- Create an account
- See member benefits
- Answer questions
- Ask the community
- See product news
- Connect with creators