Bar visualisation of parameters in midi mode

JayB
JayB Member Posts: 3 Member
edited June 2022 in Maschine

I used to use the original mk 1 (now using mk3) and it had an option when you press shift in midi mode, display parameters as values or bar. I can't seem to find this anywhere now, is it possible to activate?

Tagged:

Best Answers

  • D-One
    D-One Moderator Posts: 2,811 mod
    Answer ✓

    Holding Shift works for me with the M+ and as far as I remember it worked the same in the MK3, what shows up for you guys when you hold Shift?


  • JayB
    JayB Member Posts: 3 Member
    Answer ✓

    Nothing was showing up when pressing shift, but then I figured out the problem - I had to activate the knobs and pads pages in the controller editor. Now it works as it should. Thanks, the photo helped to know there must be a solution 😊

Answers

  • Uwe303
    Uwe303 Moderator Posts: 2,966 mod

    Hello,

    seems to be gone in editor too for mk3, my studio still has the option.

  • D-One
    D-One Moderator Posts: 2,811 mod
    Answer ✓

    Holding Shift works for me with the M+ and as far as I remember it worked the same in the MK3, what shows up for you guys when you hold Shift?


  • JayB
    JayB Member Posts: 3 Member
    Answer ✓

    Nothing was showing up when pressing shift, but then I figured out the problem - I had to activate the knobs and pads pages in the controller editor. Now it works as it should. Thanks, the photo helped to know there must be a solution 😊

Back To Top