Traktor/Mac: How to pre-listen via Audio6 Soundcard?

hwayoung
hwayoung Member Posts: 2 Newcomer

Hey there, I need help with the following set-up:

• Traktor (Mac)

• Audio6 (Soundcard)

• Amp/Speaker

• Headphone

but no external Mixer.

I have plugged the Amp to Audio6 Frontpanel > Main Output (Chinch), works well so far.

But how to connect the Headphones, so that I can pre-listening to the other deck?

Thank you in advance

Sascha

Tagged:

Answers

  • hwayoung
    hwayoung Member Posts: 2 Newcomer

    So, in Traktor, I have configured

    Output Monitor: Ch A left & right

    Output Master: Main Left & Right

    Then, on the Audio6-Soundcard, I have plugged the Amp to

    front panel -> Main Out

    and the headphones (via 3,5 to chich adaptor) plugged to the back panel -> CH A left & right, but there is no signal coming out, even if I swap master & monitor. No music is being played via Ch A. Same with Ch B.

    Can you please help me with this?

    Thank you in advance and kind regards

  • Karlos Santos
    Karlos Santos Member Posts: 136 Advisor

    Welcome to the forum.

    You need to connect the headphones to the front Main 1/4" jack input. That's where Traktor will route the monitor output. Connect your Cinch/RCA cable to Outputs 3 & 4 to go to your amp/speaker.

    The routing is:


    Let me know how you get on.

    Karlos.

Back To Top